Your furnace is a key part of your home. Without one, you wouldn’t be able to keep warm during the winter. Yet furnaces can have some problems that are more typical than others.

Let’s review these problems and discuss what they might cost to fix so you know before you contact an HVAC technician. Some of the most common furnace repair problems involve:

  • Furnace won’t turn on
  • Furnace doesn’t stay lit
  • Furnace won’t blow hot air
  • Furnace won’t turn off

1. My Furnace Will Not Turn On

There are a couple of reasons why your furnace won’t turn on, so make sure to go through all of them.

  • Is your thermostat set right? Make sure it’s on “heat,” “auto” and that your preferred temperature is higher than the room’s current temperature. If you use a programmable thermostat, make sure it has new batteries.
  • Is the circuit breaker tripped? Your furnace can’t operate if it doesn’t have electricity. Reset the switch if it’s facing the outside of the electrical panel.
  • Is the furnace switch off? Your furnace has a power switch found on or close to it. Because this switch resembles a light switch, it’s easy to accidentally turn it off. If it was off, it may take your furnace a few minutes to turn on.
  • Is the air filter clean? A dirty air filter can create a lot of problems for your furnace. Get a new one if you can’t see light through it.

Estimated Repair Cost

This issue can be complex, so the estimated cost to repair it varies according to what’s wrong.

2. The Furnace Isn’t Staying Lit

Your furnace follows a specific sequence when it begins heating your home.

  1. Your thermostat detects the temperature has dropped and tells your furnace to start running.
  2. The draft inducer fan turns on to bring in fresh air for combustion.
  3. The gas valve opens for the burners, which are ignited electronically.
  4. The flame sensor signals to your furnace the burners have been ignited.

If something is wrong during the sequence, your furnace will shut down as a safety precaution.

A couple of possible causes for this problem include:

  • Dirty or malfunctioning flame sensor. If the sensor doesn’t sense a flame, it will turn off your furnace to prevent natural gas from getting into your home. The ignition process corrodes flame sensors over time. While cleaning during annual furnace maintenance can help, yours may ultimately need to be replaced.
  • Bad limit switch. This safety feature will turn off your furnace if it senses backdrafting. Backdrafting is dangerous, since carbon monoxide and natural gas can leak into your home. These switches can malfunction due to age, damage or dust accumulation.
  • Old thermostat. If your thermostat isn’t working properly, your furnace won’t be able to operate.
  • Dirty air filter. A dirty air filter can limit airflow and cause your furnace to shut down to prevent overheating. Make sure to replace yours every 30 to 90 days, or anytime you can’t see light through it.

Estimated Repair Cost

These costs are estimates, so it’s necessary to note yours may vary based on your furnace’s brand and model.

  • Flame sensor: $350–$500
  • Limit switch: $150–$300
  • Thermostat: $150–$350
  • Furnace filter: $10-$30

3. My Furnace Is Blowing Cold Air

In many cases, this problem is tied to a wrong thermostat setting or a dirty air filter that’s limiting airflow. Follow the steps above to fix the issue.

4. The Furnace Can’t Stop Running

If it’s extremely cold outside or you like your home to be toasty, your furnace may be running for a long time.

If this isn’t what’s happening, ensure your thermostat is set correctly and working properly. If your fan setting is at “on,” the blower motor will be running even when the furnace isn’t, so it’ll seem like your furnace is on all the time.

Alternatively, there might be an issue with the blower motor or your ductwork may be leaking air, forcing your furnace to run continuously to make up for the air loss.

Estimated Repair Cost

These costs are estimates, so it’s necessary to note yours may be different based on your furnace’s brand and model.

  • New blower motor: $250–$800
  • Seal ductwork: varies based on square footage

Cytech Heating & Cooling L.C. Can Solve Your Furnace Issues as Soon as Possible

Furnace problems can be an expensive headache, but not when you call Cytech Heating & Cooling L.C.. We’ve been delivering the quality, affordable furnace repair McAllen homeowners have trusted since year. Contact us at 956-553-3265 to request your free estimate today.